![]() Heck, whittle some pegs from branches to join the laths. Come to think of it, baling twine or wire would probably work for that as well. Then join 'em with your hardware of choice. Position a screw every 6 inches to 8 inches and sink it in place around the entire lattice panel. Sink it through the lattice into the post to secure it in place. Place a 2-inch screw up to the top corner of the panel. Position it so it lies on the upright post 1 inch from the edge of the post. With a bit of fiddling you can line them up as in Fig. Place the lattice panel up to the opening. This is, after all, a garden prop we're making, not a fine cabinet!Īfter all your laths are cut to length and pre-drilled, lay them out with half as a bottom layer angled to the right, half as the top layer angled to the left. You could also pre-drill the lath, push a nail through and bend it over. You could also use nuts and bolts, but if you don't have them laying around that might make for an expensive pea trellis. I pre-drilled half of the lath wide enough so the screw would turn freely in the hole and pre-drilled the other half smaller so the screw would bite. I had a box of machine screws from some unknown prior project which I used. The laths need to be joined where they will overlap but still be able to pivot. The size of the holes will depend on what you will use to join the lattice together. They have holes drilled 6 inches from each end and one foot apart along the length of each lath as in Fig. The lattice is made from ten 4 foot lengths of lath and two 3 foot lengths. It can also be used as garden lattice as the vinyl material resists wear from the weather and moisture. It features a low-maintenance design that is easy to install and maintain. This trellis is composed of the following components: a lattice and two legs. White Classic Vinyl Lattice features a vinyl construction that is both weather and impact resistant. My trellis turned out to be 4 feet tall and about 8 feet long when fully extended, and probably took about an hour and a half to make. If your materials or the plants that will be climbing on it push you to interesting modifications, post pictures or comments! My purpose in making this trellis was half getting ready for the spring garden and half spring-cleaning by using up that pile of lath! The full lengths were four feet long, which determined my final design. As you can see in the third photo, I had on hand a pile of lath left over from our neighbors' remodeling project. Proven fact.įollow along with what I did, or adapt it to suit you own situation and materials. Also the stylish lattice makes the peas happier. It'll shrink right down for winter storage and stretch out to match that row of peas. Quick! Plant those delicious snap peas, and then rush straight to the workshop and build them this trellis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |